Flexing Pub Share

Flexing and extending of joints is what enables us to move and stay in balance. The most important flexing is that of the ankles, knees and hips, all fundamental movements of good skiing.

Flexing/extending the ankles is useful for fore-aft balance (Dorsiflexion and plantarflexion). The knees for vertical movements and the hips for fore/aft, vertical and lateral movements, but really they all work together all the time.

As a movement, we use flexing to mean the flexing of the leg, i.e. when it becomes short from long, flexing the ankles, knees and hips together.

Flexing: relaxing and shortening the leg

Flexing or shortening the leg is important for weight transfer, releasing, tipping, inclination into the turn and others and a prevalent mechanism in the high end expert skiing, to both release and engage. The flexing starts by relaxing the leg muscles and allowing the leg to flex.

Biomechanically, when we say "flexing the leg" we actually mean to flex the knee and hip, resulting in a short leg, while keeping the torso at roughly the same forward angle and the boots largely under the hips, so with an accompanying dorsiflexion of the ankles, as permitted by the boots. The hip flexes in the fore/aft plane as well, to allow the upper body to remain stable.

We flex the outside leg to release the previous turn and the inside leg to create the new turn:


Flexing is part of most effective releases, see Flexed release and Retraction release.

See Flexing and extending for a full picture.

Flexing enables tipping

Flexing enables tipping - perhaps most evidently in this photo:


Looking at the inside leg above, you notice that it is very flexed and this allows the ankle to tip the boot and leg. That leg is also off the snow and you can see how the ski diverged slightly from the outside ski - that is a result of the inversion of the foot and a sure sign that the skier is tipping the inside boot from the foot and ankle as opposed as tipping from the knee (femur rotation).

A long leg is very hard to tip on edge, because you have to leverage and move the hips sideways and down. Also, a long leg tends to be weighted, which makes it even harder to tip on edge. It also takes time to establish tipping angles, with an early long leg, see Inclination vs angulation.

"Bend the knees" is perhaps the most used phrase in all of ski instruction, for a good reason!

So, when both legs are shorter, at the top of the turn, they are much easier to tip on edge.

Benefits

The benefits of learning how to flex well on piste extend to all areas of skiing. For instance, flexing is critical for good bump skiing - the deeper you can flex to absorb the moguls, the better your line can be and the more speed you can carry through the moguls.


Flexing puts you back, too

As a geometrical relationship, when the legs are flexed, the hips are well behind the boots as you can see in the photo above - as with everything else, flexing must be used in relation to other movements (see Recentering).

I don’t consider the presence of bent legs a good thing always. Just puts him in the backseat. No float! HeluvaSkier

However, having the hips behind the boots momentarily, when the skis are light (so no pressure is required) is not a bad thing - read more about Float, flexing and ski performance.

The timing of flexing

We look at flexing and extending of the legs individually, in different parts of the turn, with different results.

Member-only content avilable (115 words).
To see more on this topic, you need a membership. (Member)

More reading

Sessions

Drills:

More to read:

Start improving your release


Was this useful?    

By: Razie | 2015-08-18 .. 2021-12-29 | Tags: wiki , flexing , biomechanics , fundamental , technique , essentials


Viewed 7732 times ( | History | Print ) this page.

You need to log in to post a comment!